LP 20/70/110-Degree Swivel Adaptor for Regulator

This Low Pressure (LP) 9/16 inch UNF Male to 9/16 inch UNF Female 20/70/110 degree Swivel Adaptor is often used to allow underarm routing of a low-pressure regulator hose.

Enables comfortable, streamlined underarm routing of a regulator hose.

Does your regulator second-stage feel uncomfortable in your mouth when diving? Does it feel like it's trying to pull out of your mouth when you turn your head? If these are problems you have experienced while diving then you may need a hose adaptor that can eliminate this problem. This 20/70/110-degree Swivel Adaptor makes your primary second stage regulator more comfortable while you dive. The adaptor is installed between your second stage regulator and the regulator low-pressure hose. It allows you to route the hose under your right arm instead of over the shoulder. This adaptor provides a more comfortable feeling and can eliminate the pulling effect of the regulator found with over the shoulder routing.

Okay, so different people refer to this as a 20, 70 or 110-degree adaptor. It just depends on your point of reference when you measure the angle.

This 20/70/110 Degree Angled Swivel Adaptor attached attaches between the regulator second stage and its low-pressure hose routing the hose down the diver's chest and/or under the arm, which eliminates hose push giving you a more comfortable bite on your mouthpiece. Your hose will lay closer to your body (under your arm) helping to eliminate tangles and improve streamlining. Also liked by hookah divers on their regulator whip hose.

This low-profile adaptor is NOT an omni-directional swivel.

Sidemount divers use the 20/70/110 Angle Adaptor to route their hoses down their chest to the bottles eliminating the need to route the hose around the neck.

Some people, including us, prefer this 20/70/110 degree adaptor over the 90 degree adaptor because it angles the hose slightly away from the neck and face.

The 9/16"-18 UNF Male end of this adaptor screws into the standard 9/16"-18 UNF Female fitting on the end of a standard regulator hose.

The 9/16"-18 UNF Female end of this adaptor accepts the standard male 9/16"-18 UNF Male connector on most second stage regulators.

The adaptor is made from corrosion-resistant chrome-plated brass for long life and low maintenance. Designed for low-pressure hoses using 200 psi (13.8 bar) or less. Equipped with Viton O-rings and factory cleaned, so it's safe for use with enriched air Nitrox. This adaptor can also be used for Octopus regulators to greatly improve your alternate air source hose routing. Easy to install, improve your comfort while diving with the Sonar LP 20/70/110 Degree Swivel Adaptor.

LP 20/70/110 Degree Swivel Adaptor

• Makes Primary Regulator More Comfortable while Diving
• Routes Hose Under Right Arm instead of Over Shoulder
• Often Used on Octopus to Improve Hose Routing
• Installs Between Second Stage and Regulator Hose
• Chromed Brass Construction
• Factory Cleaned - Viton O-Rings
• Nitrox Compatible
• Low Pressure Use Only - Below 200 psi (13.8 bar)
• Easy to Install