Apeks 1st Stage Regulator DIN Conversion Kit - Co-moulded

This Apeks DIN to Yoke Adaptor Assembly is a Conversion Kit to permanently replace the Yoke ('A') clamp fitting on an Apeks First Stage Regulator with a male DIN 300 bar fitting.

Perhaps you started diving with Yoke style cylinder valves and Regulator, but you feel the higher cylinder pressure available with DIN cylinders will be an advantage to your style of diving. Or you just want to switch from Yoke/Int to the safer DIN system. Well this converter kit will allow you to do just that, shed the yoke and increase bottom time with this 300 bar (4,350 psi) DIN conversion kit.

So you have an Apeks regulator with an international Yoke ('A') clamp fitting that you normally connect to cylinders with Yoke ('A') clamp cylinder valves. But now you want to be able to use your Apeks regulator to connect to cylinders with DIN valves. Just purchase this Apeks Regulator Yoke to DIN Converter. Then you unscrew the Yoke ('A') clamp fitting on your Apeks regulator. Then in its place, you screw this Apeks Yoke to DIN adaptor into your Apeks regulator. Now your Apeks regulator has a male DIN fitting and can be connected to cylinders with DIN valve fittings. It's that easy!

Fits both DIN 300 and 232 bar valves. Perfect for the travelling diver.

DIN Assembly is constructed from Marine Grade Corrosion Resistant Chromed Brass.

Apeks First Stage Regulator DIN Conversion Kit Features

• Convert First Stage Regulator from Yoke/Int to DIN Connection
• Allows Regulator Use with 300 bar High Pressure Cylinders
• Safer way to connect your regs to your cylinder valve
• Marine Grade Chromed Brass Construction
• Great for Traveling Divers
• Service Pressure: 300 bars (4350 psi)

Colour:
RA112118 (AP0620) - Co-moulded handwheel
RA112112 (AP0211) - Bright Chrome
RA112115 (AP0211/S) - Satin

This item should be installed by an authorised Apeks dealer or Service Centre.

Note: This item cannot be delivered outside of Australia.