Shop by Category
Information
The Sea & Sea O-ring Set for the Battery Cap of the YS-01, YS-02, YS-03, YS-90 Series, YS-110 Series, YS-D1, YS-D2, YS-27 and YS-30 Underwater Strobes is a must for the serious underwater photographer. The set includes all diver replaceable O-rings for the strobe. Sea and Sea recommends O-rings to be replaced annually, or when you are in doubt of their integrity. This O-ring Set makes a great Save-a-Dive Kit item.
O-rings are the most important components of your underwater camera system. If the O-ring is lubricated, it will be elastic enough to shape itself uniformly around the channel providing a proper seal. If it is dry, there will be too much friction to allow it to reshape itself uniformly. It will not safeguard against flooding. Underwater photographic equipment cannot be watertight unless the o-rings that seal it are flawless. Always carry spare O-rings in your camera case. Replacement O-rings for all Sea and Sea equipment are available in protective blister packs.
Every time you open the photographic equipment to change film or batteries, examine the O-ring and service if necessary. Always clean and lubricate after every diving day. When in doubt about the sealing capability of an O-ring, always discard and replace. Never use a sharp or pointed object to remove an O-ring! Use Sea & Sea's O-ring remover tool.
Don't over grease! Too much grease attracts debris that will disrupt the seal and cause flooding. Silicone grease is not a sealant, it only protects the O-ring from abrasion. A perfectly greased O-ring looks moist and shiny.
Drop Ship
This is not a regularly stocked item in our Rye dive shop. It will be ordered for you from the manufacturer upon request and typically shipped directly from them to you the same day thus resulting in no delay in delivery. However, if they are out of stock this item becomes a special order from Europe typically resulting in a 4- to 6-week delay.
Note: This item cannot be delivered outside of Australia.
