Apeks WTX-D60 Donut Wing - Twin Cylinder

The Apeks WTX-D60 Twin Cylinder Donut Wings with 60 lb lift capacity are designed for twin set diving and perfectly complement the Apeks range of twin manifolds and the Tek3 regulators. Often referred to as donuts, the WTX-D60 wings are oval shaped air cells or bladders that are not permanently attached to a harness. Not only are these donut wings streamlined, but due to their shape being a continuous loop, they are very stable underwater. There is no dramatic shift of air from left to right.

Much thought and design work has gone into the Apeks twin cylinder wings. Special attention has gone into the fabrics and hardware selected, the shape of the wing, the water drainage and the construction techniques. When you buy Apeks, rest assured that you are buying the best product available.

Apeks WTX-D60 Donut Wing Features

• Inflator:
  • K style with brass buttons
  • Low profile 16 inch long oval-shaped hose
  • Safety cable to prevent hyper-extension
  • Positioned off-centre so as not to interfere with regulator 1st stage
• Dump Valve
  • Low profile flat valve
  • Positioned in front, lower-left side
• High-efficiency drains to drain water quickly
• Access zipper is located on front side to prevent abrasion from cylinders and tank bands
• Able to accept an optional Retractor Kit, P/N: 388300
• Centre foot print matches the Apeks plate.
• 3 upper grommets allow various height settings coupled with a lower slot that compensates for misaligned band bolts.
• Materials:
  • Exterior: 1000D Armorshield Cordura
  • Inner air cell: 22 mil (.022) thick black urethane
    Zipper: heavy duty YKK #10 plastic zip and slide

Apeks WTX-D60 Donut Wing Specifications

Note: This item cannot be delivered outside of Australia.